Request Information Download PDF Configure Output Connector
GT-41130-20VV-x.x-T2 GT-41130-20VV-x.x-T2
Information
Model NumberGT-41130-20VV-x.x-T2
DescriptionGT-41130-20VV-x.x-T2, ITE Power Supply, Desktop/External, Regulated Switchmode AC-DC, , Input Rating: 100-240V~, 50-60 Hz, IEC 60320/C8 AC Inlet connector, Class II, Non-Earth Ground (aka "Figure-8"), Output Rating: 24 Watts, 12-24V in 0.1V increments, Approvals: GOST-R NrCAN CE WEEE Double Insulation PSE RoHS 2 CB China RoHS FCC IP40 Level V NEMKO RCM Ukraine VCCI UL/cUL LPS Saudi SGS (Brazil) Serbia Malaysia HKSM CCC PSE PSE
Agency Documentshttp://www.globtek.info/certs/GT-41130-T2-T3-T3A/
CE EC-Declaration for MedicalContact GlobTek for more information
CE EC-Declaration for Industrial/Commercial/ITEhttp://globtek.force.com/models/ec_declaration?id=a0Oa000000C2VWHEA3
RoHS/RoHS2 Declarationhttp://www.globtek.com/pdf/rohs_cert/a0Oa000000C2VWHEA3
REACH Declarationhttp://www.globtek.com/pdf/iso_certificates/REACH.pdf
Conflict Minerals Declarationhttp://www.globtek.com/pdf/conflict-minerals.pdf
Model Parameters
TypeDesktop/External
TechnologyRegulated Switchmode AC-DC
CategoryITE Power Supply
Input Voltage100-240V~, 50-60 Hz
I/P Amps (A)0.8A
Wattage (W)24
Vout Range (V)12-24
EfficiencyV
Ingress Protection
Size (mm)50*81*31
EnclosureUser-added image
Rating Table
Model NumberVoltageAmps (A)Watts (W)RFQ
GT-41130-2012-2.0-T210220RFQ
GT-41130-2012-T212224RFQ
GT-41130-2024-9.0-T2151.624RFQ
GT-41130-2024-8.0-T2161.524RFQ
GT-41130-2024-6.0-T2181.3323.94RFQ
GT-41130-2024-T224124RFQ
SpecificationsA) ELECTRICAL SPECIFICATIONS:
01. Input Voltage: 100-240 Vac
02. Input Frequency: 47 - 63 Hz
03. Output Regulation: +/- 5% measured at the output connector
04. Line Voltage Regulation: +/- 1% typical measured at output connector
05. Output Ripple (Vp-p): +/-1% or 150 mV whichever is greater, measured at 20 MHz bandwidth with 0.1 uf ceramic capacitor in parallel with 10 uf electrolytic capacitor connected at the end of the output connector at nominal line
06. Turn-ON/OFF Overshoot: 5% maximum, 1 mS typical recovery time for 25% to 50% step load
07. Turn-ON Delay: 1 sec. typically
08. Hold-Up Time: 8 mS typical @ nominal input voltage and full load
09. Inrush Current: 30/60A typical at 115/230 Vac
10. Switching Frequency: 65 KHz typical

B) PROTECTION
01. Over-Voltage: Electronically Protected Zener clamp across the output
02. Short Circuit: Electronically Protected unit will auto recover upon removal of fault
03. Input Protection: Input line fusing

C) SAFETY
01. Dielectric Withstand Voltage: 4242Vdc from primary to secondary
02. Touch Current: <0.25 mA at 240Vac

D) OTHER:
01. MTBF: 200,000 Hours @ 25°C ambient temperature
02. Operating Temperature: 0°C to 40°C ambient temperature
03. Humidity: 0% to 90% relative humidity
04. Storage Temperature: -10°C to 80°C
05. Cooling: Convection

E) ENCLOSURE
01. Housing: High impact plastic, 94V0 polycarbonate, non-vented
02. Size: 50 x 80.6 x 31mm +/-1.0 mm
03. Markings: Label and/or Pad Printed and/or Molded in the case
Derating Curve
Qty (ea.)/Carton80
Individual Box/Gift Box Size (mm)110*57*70
Individual Box/Gift Box ColorWhite
Master Carton Size (mm)463 x 318 x 305
Gross Weight (kg)15.6
Label Width (mm)39.6
Label Height (mm)59.6
Input Configuration
DescriptionIEC 60320/C8 AC Inlet connector, Class II, Non-Earth Ground (aka "Figure-8")User-added image

Mates with IEC 60320/C7 Plug

Standard International IEC 320/C7 Cordsets

Below are standard cordsets which are "not included" (unless stated above); these may be purchased separately or packaged with the power supply. Please contact your Sales Engineer if the style required is not shown below. Many more available in different lengths, colors or cable material.
 

2 Conductors (No Ground) IEC 320/C7 (Figure "8")

4511116F703A(R)

N. American

NEMA 1-15P

IEC 320/C7

1830

6

5014112M703A(R)

Australian

AS 3112

IEC 320/C7

2000

7

4533501M8703(R)

China

GB 2099.1

IEC 320/C7

1830

6

2074112M703A(R)

European

CEE 7/16

IEC 320/C7

2000

7

451J3401M8703(R)

Japan

JIS 8303

IEC 320/C7

1830

6

6104112M703A(R)

UK

BS1363

IEC 320/C7

2000

7

Output Configuration
Common output connector options:
Click to add to your request.






L Type (Coaxial 5.5x2.5mm plug) C Type (Coaxial 5.5x2.1mm plug) K Type (Coaxial 3.5x1.3mm plug) LL Type (5.5x2.5mm Locking 760k type) CL Type (5.5x2.1mm Locking S761k type) Magnetic Connector






YL3 Type (KPPX-3P) YL4 Type (KPPX-4P) EJ1/2/3/4/5 (EIAJ RC-5320A type connectors) MSB Type (Micro USB) USBC Type (USB Type C) Inquire for custom design

For a comprehensive list of options, click here

Contact GlobTek for your specific requirements or custom solutions.

Approvals
LogoDescription
No Logo CB Certificate IEC 60950-1:2005 (2nd Edition), Am 1: 2009 + Am 2:2013
User-added imageCCC to GB4943.1-2011 GB9254-2008 GB17625.1-2012
User-added image  CE Mark: tested to comply with EN55022:2006/A1:2007 Class B, EN610003-2, EN610003-3 including EN61000-4-2, EN61000-4-3, EN61000-4-4, EN61000-4-5, EN61000-4-6N EN61000-4-11; EMI: Complies with EN55011 CLASS B and FCC Part 15B - On label or Molded in case
User-added imageCHINA SJ/T 11364-2014, China RoHS Chart: http://en.globtek.com/globtek-rohs.php
User-added imageUL60950-1, cULus to UL 60950-1, 2nd Edition, 2007-03-27 and CSA C22.2 No. 60950-1-07, 2nd Edition, 2007-03
User-added image

Double Insulation - Mark is on the label or Molded in the case
User-added image
FCC PART 15 CLASS B
User-added image
 
GOST-R mark for Russia(Document: http://www.globtek.com/html/iso_certificates/GT_GOST-R.pdf). 03/15/2015. Due to lack of demand, GlobTek will not be renewing it's GOST certification. Please contact your sales engineer for pricing on EAC.
User-added image

Hong Kong Safety Mark License IEC60950-1:2005 + A1:2009
User-added imageIndoor Use Only - Mark is on the label or Molded in the case
IP40Ingress Protection: IP40 to IEC60529:2001 Protection against granular foreign bodies
User-added imageJAPAN TUV R-PSE, Cert. No. JD 50313285, to J60950-1(H26) , J55022(H22),J3000(H25)[15V or less]. Please reference the following website for guidelines on PSE regulations: http://en.globtek.com/importing-ite-and-medical-power-supplies-ac-adaptors-to-japan/
User-added imageJAPAN TUV R-PSE, Cert. No. JD 50314327, to J60950-1(H26) , J55022(H22),J3000(H25)[15V or less]. Please reference the following website for guidelines on PSE regulations: http://en.globtek.com/importing-ite-and-medical-power-supplies-ac-adaptors-to-japan/
 User-added image

Efficiency: complies to section 301 of Energy Independence and Security Act (EISA) complies with Energy Star tier 2 (North America), ECP tier 2 (China), MEPS tier 2 (Australia), Code of Conduct (Europe)
LPSLimited Power Source
No Logo Malaysia ST Release Letter GT-41130-T2 -T3(A) IEC60950-1:2005 (ED.2) + A1:2009 No logo
User-added imageNEMKO EN60950-1 2nd edition
User-added imageEEV1191Natural Resources Canada (NRCan): CSA Standard C381.1-08, QSP NRCAN EEV1191; http://shop.csa.ca/en/canada/energy-efficiency/cancsa-c3811-08/invt/27024802008
User-added imageJAPAN TUV Rheinland-PSE GlobTek Inc to J60950-1(H26) , J55022(H22),J3000(H25).Please follow the procedure listed in the following link for proper import to Japan: http://en.globtek.com/importing-to-japan.php.
User-added imageRCM 5291; Australia and New Zealand Regulatory Compliance, Mark (http://rcm.standards.org.au/rcmfaq/rcmfaq.htm
RoHS 2RoHS 2: Complies with EU 2011/65/EU and CHINA SJ/T 11363-2006 http://www.ce-mark.com/Rohs%20final.pdf

User-added image
Saudi Arabia approval to IEC 60950-2005
User-added image
Serbia Approval - Conformity mark must be at least 5 mm high.
User-added image
FONTE DE ALIMENTAÇÃO DE ITE
SGS (Brazil) to IEC 60950-1_2005 + A1_2009 +A2_2013 (10 - 24 Volts)
User-added imageUkraine UKRSepro (Document: www.globtek.com/html/iso_certificates/GT_Ukraine.pdf)
User-added imageJapan: Voluntary Control Council for Interference (VCCI)
 User-added imageWEEE: Complies with EU 2012/19/EU (http://ec.europa.eu/environment/waste/weee/index_en.htm) Mark is on the label or Molded in the case
Popular Products
SKUVolts OutCurrent Out (Amps)Connector
136649122.0Female Barrel 5.5*2.1*11mm No internal Spring Clip nor Locking Notch or Equal
167019121.25Ferrul (Non insulated type)
163590122Female Barrel 5.5 * 2.5 * 11mm No internal Spring Clip nor Locking Notch or Equal
177174122.0Female Barrel 5.5*2.1*11mm No internal Spring Clip nor Locking Notch or Equal
168277122Female Barrel 5.5 * 2.5 * 10mm No internal Spring Clip nor Locking Notch or Equal
168510122.0Socket for interchangeable o/p connectors
136693241Stripped 30 +/-5mm; Tinned 9 +/- 2mm or Equal
News Releases
TitleWeb Link
ITE Information Technology (60950-1) Power Supply AC Adapter certified by Australia SAA Approvals to mark the RCM and/or SAA130359EA per joint Australia and New Zealand national standard AS/NZS 60950.1:2011, Model Series GT-41130-T2.http://en.globtek.com/news.php/ite-information-technology-60950-1-power-supply-ac-adapter-certified-by-australia-saa-approvals-to-mark-the-rcm-andor-saa130359ea-per-joint-australia-and-new-zealand-national-standard-asnzs-6095012011-model-series-gt-41130-t
Class I & II 24W (Watt) Desktop Switching Power Supplies updated to latest Australia and New Zealand standard AS/NZS 60950.1:2011 with RCM for model series GT-41130-T2 and -T3(A)http://en.globtek.com/news.php/class-i-ii-24w-watt-desktop-switching-power-supplies-updated-to-latest-australia-and-new-zealand-standard-asnzs-6095012011-with-rcm-for-model-series-gt-41130-t2-and-t3a
Serbia EMC and LVD Certificate
GT-41130-T2 -T3(A) IEC60950-1(Ed.2):2005 + A1:2009

Request Info