GT-93020-0624 DIN Rail ICT/ITE Power Supply Datasheet

Model NumberGT-93020-0624
Agency DocumentsPending
CE EC-Declaration for MedicalContact GlobTek for more information
CE EC-Declaration for Industrial/Commercial/ITE
CE EC-Declaration for HouseholdContact GlobTek for more information
UKCA-Declaration for MedicalContact GlobTek for more information
UKCA-Declaration for Industrial/Commercial/ITE
UKCA-Declaration for HouseholdContact GlobTek for more information
Morocco SDoC Declaration
RoHS/RoHS3 Declaration
Prop 65 Statement
REACH Declaration
Conflict Minerals Declaration
Model Parameters
TypeDIN Rail
TechnologyRegulated Switchmode AC-DC Power Supply AC Adaptor
CategoryICT/ITE Power Supply
Input Voltage Range (V)16-34Vac, 50-60Hz
Max Input Current (A)2.0A
Max Output Power Rating (W)6
Output Voltage Range (V)24
Ingress ProtectionIP21
Size (mm)
Enclosure             DIN RAIL: COMPLIANT WITH EN50022, 3 RAILS:

User-added image
Rating Table
Model Number (Final ordering #/Part No to be defined)Voltage (V)Current (A)Power (W)RFQ
* (Final ordering #/Part No to be defined)
01. Input Voltage: 16-34VAC
02. Input current: 2.0A RMS Max.
03. Input Frequency: Specified 47-63 Hz, Nameplate rated 50-60Hz
04. Output Voltage: 24 Vdc
05. Output current: 250 mA continuous, 1000 peak for 1mS repeating every 4 mS for the next 5 minutes
06, Output Power (rated): 6 Watts continuous, 24 Watts peak
07. Output Load Regulation: +/- 5% measured at the output connector
08. Line Voltage Regulation: +/- 1% typical measured at O/P connector
09. Output Ripple :240 mV p-p, At 20 MHz, bandwidth with 0.1uF ceramic capacitor in parallel with 10 uF, electrolytic capacitor connected at the end of output connecat nominal line
10. Turn-ON/Turn-OFF overshoot: 5% maximum,1 mS typical recovery time for 25% step load
11. Turn-ON Delay: 1 Second Max
12. Hold-Up Time: 20 mS hold-up time at rated power (2.4W/100mA) acceptance criteria 'A', 40 mS hold-up time when load equals (1.3W/56mA) acceptance criteria 'A'
13. Switching Frequency: 65 KHz typical
14. Efficiency: 75% MIN, measured at the full load, 24Vac Input

01. Over-Voltage:protected with zener clamp across output
02. Short Circuit:protected, unit will recover upon removal of fault input line fusing

01. Dielectric Withstand Voltage: 2000 Vdc from primary to secondary
02. earth leakage: <3.5mA @ 34Vac input voltage
03. Ingress protection: IP21

01. MTBF: 200,000 Hours @ 25°C ambient temperature, 77,500 Hours at 45°C
02. Operating Temperature: -20°C to +65°C ambient temperature
03. Humidity: 0% to 90% relative humidity
04. Storage Temperature: -30°C to 70°C
05. RoHS 2: Complies with EU 2011/65/EU China SJ/T 11363-2006

01. Housing: PC94-0 94-V0, Plastic material or equivalent
02. Size: 70.0*55.0*30.0 +/-1.0 mm
03. Weight: 80 g maximum
04. Markings: Label and/or Pad Printed and/or Molded in the case
Derating CurveN/A
Qty (ea.)/Carton60
Individual Box/Gift Box Size (mm)100*53*65
Individual Box/Gift Box ColorWhite
Master Carton Size (mm)415 x 280 x 230
Gross Weight (kg)7.4
Label Width (mm)24.7
Label Height (mm)27.7
Input Configuration
DescriptionWAGO P/N: 734-132 (MCS-MINI SERIES 734 MALE 2 PINS)

Below follows a link to the latest regulatory certifications and marks for this specific product. National standards as well as certification schemes are constantly changing and so is the set of certification marks and symbols applicable to this product. Various standards, marks and symbols, and certificates are subject to change at any time without notice.

Additional standards or unique country certifications are available upon request. Please contact Globtek to request a quotation.

User-added imageIndoor Use Only - Mark is on the label or Molded in the case
User-added imageCHINA SJ/T 11364-2014, China RoHS Chart:
LPSLimited Power Source 60950
RoHSSpecifications of directive 2011/65/EU Annex VI (ROHS-2) with amendment 2015/863-EU (ROHS-3)
User-added imageUkraine UKRSepro (Document:
 User-added imageWEEE: Complies with EU 2012/19/EU ( Mark is on the label or Molded in the case
Popular Products (Stock items)
SKUVolts OutCurrent Out (Amps)ConnectorRFQSample Request

How Does an AC-DC Wall Adapter Work?

The AC to DC adapter or external power supply consists of a power supply which is enclosed in a housing similar to an AC plug, hence the term plug type, wall plug in, plug-in or plugtop power adapter. The power supply is plugged into the mains socket and the AC Voltage is then converted by the AC to DC adapter power supply into a DC voltage that is fed into the appliance via the output cable connection.

Request Info
Request a Quote
Can we help you?
Can we help you?